Roundover 2 Cutter 3/16″ (5 mm)

The Festool 3/16″ Roundover Bit HW R5‑OFK 500 is built for controlled edge profiling on solid wood and plastic edge banding using the Festool OFK 500 trim router. It produces a smooth R5 round‑over that softens edges evenly while maintaining a consistent profile across small parts and detailed workpieces.

A hollow, direct‑thread design mounts directly onto the router shaft with no collet required. This reduces run‑out and vibration at the cutter, helping maintain a steady cutting radius and predictable depth throughout the pass. The low‑profile body allows routing in rabbets or across stacked panels where clearance is limited.

Two precision‑ground carbide cutting edges provide long service life while maintaining a clean, even cut. The cutting radius transitions into a 5° relief angle, improving exit quality and reducing surface marking along finished edges.